(no title)
I didn’t think I would get much done last night, but it was a productive session. I can’t wait to work on this thing for more than an hour at a time–next weekend. During the week there are too many things going on, especially since I’m flying twice after work this week. I’ll probably go back to one lesson after work per week soon.
I final drilled the HS rear spar reinforcement bar to the rear spar. I couldn’t wait to try out the debur tool in the cordless screwdriver, so I deburred all of the holes. Of course then I final drilled the hinge brackets to the spar and enlarged the holes for the middle rib. I’ll have to go back and debur those again. It’s probably better to do all of the trial assembly and drilling at one time, then mark everything, disassemble, and finally debur.
Despite my prior complaints about the air cleco tool, it’s awesome. I was able to move and remove clecos with ease and much faster than without it. Definitely worth $25.