(no title)
Started working on the HS front spar. Shaped the ends of the HS-710 and HS-714 reinforcement angles. I did that on the bench sander, but it would have been much quicker to do some initial cuts with a band saw. Final drilled the reinforcement angles to the spar, then bent the 6 degree bend on the ends with a vise and hand seamer. Cut the extra flange off of HS-702. I followed the directions and drilled the #30 hole then used the Unibit to make a 1/4″ hole. That worked really well. From there I used the spins. I tried to straighten out the little bit of bend that was left over. I went back to the bench sander to smooth the sharp corners on the cuts. After that I put the 6 degree bends in the ends with the vise and some blocks of wood. Then I clecoed the pieces together and read further on in the instructions.