Left fuel tank rib riveting
Riveted in the remaining 3 interior ribs in the left fuel tank with lots of help from Julie. Also riveted in the drain. I had planned to do a few more things, but that took long enough. Things got real messy toward the end, but MEK cleans everything right up. Used about 2/3 of the tube this time. It started getting pretty thick after about 2 hours. I had to turn up the pressure on the Semco gun to get it to flow out at a reasonable rate.
I’ve noticed a few folks puts lots of sealant around the drain. I figure I want every potential drop of water to make it to the low point, so I made sure there were clear channels between the rivet heads.
