Left fuel tank prep
I thought I was ready to ProSeal in the end ribs on the left tank, but I’m not. I figured out that I forgot to put the nut on for the coax connector. I had to cut out that wire and use parts for the other tank, re-crimp, re-solder. And then tighten down the connectors on the inboard sender plate. And then mask off areas that I don’t want ProSeal on (rear baffle, fuel vent and pick-up connector threads). And then I started looking carefully at the rivet heads that I swirled ProSeal on in previous sessions. There are several of those that I want to hit again. And then I had to figure out the rivet sizes to use in various places. But now I am fully ready. Too late to start tonight, though.
