(no title)
I worked on fitting and drilling the F-796B, C, and D, angle and spacers for the fuel tank attach point. The instructions and plans have you drill one hole and then use that to position the parts. I drilled the hole, but it was way off when I tried to fit the angle. I had to grind off quite a bit from the top of it. By the time I had it fitting well, there wasn’t much of an edge distance for the bolt at the bottom. Considering the tank attach brackets actually use the middle and top bolts, I’m not too worried about the edge distance of the bottom bolt.
I put the bottom skin back on in preparation for drilling out all the remaining holes. This point in the project uses a lot of clecos. I’m running especially short of 1/8″ clecos.